Check The Function - Prebena PKT-2-ES40-S Manual Del Usuario

Check the function

Proceed as follows for trouble-free pneumatic tool function:
Place the nose of the pneumatic tool on a piece of wood that is at
least eight centimeters thick.
Release the pneumatic tool (see section "Driving the fasteners"
starting on page 32).
In this process check the following characteristics:
Release is only executed when the safety device is
-
depressed.
A fastener must be driven into the piece of wood each time the
-
release is activated...
Use the adjustment wheel to get the desired depth-of-drive (see
page 28, except PKT-2-CLIP45-SY and PKT-2-J50 SVN).
Repeat these steps as necessary.
For the following types you can also adjust the driving force:
PKT-2-ES40-S
PKT-2-ES40-SY
PKT-2-CLIP45-SY
PKT-2-N65-S.
For this proceed as described in the section "Adjusting the driving
force" on page 29.
The pneumatic tool is now ready for operation.
CAUTION
A hazard of injury or property damage exists
when operating the pneumatic tool.
Comply with the safety instructions in the
section "Operating the pneumatic tool "
starting on page 28.
Preparing the pneumatic tool
27