Makita LS1016 Manual De Instrucciones página 11

Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
1
009498
NOTE:
If the inner flange is removed be sure to install it on
•
the spindle with its protrusion facing away from the
blade. If the flange is installed incorrectly the
flange will rub against the machine.
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the surface
of the blade matches the direction of the arrow on the
blade case.
Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed)
securely counterclockwise while pressing the shaft lock.
1
3
009500
2
3
1
4
009499
1. Shaft lock
2. Blade case
3. Hex bolt
2
3
1. Arrow
2
2. Arrow
3. Blade case
4. Saw blade
4
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
5
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Release the handle from the raised
position by pulling the stopper pin. Lower the handle to
make sure that the blade guard moves properly. Make
sure the shaft lock has released spindle before making
cut.
009524
Dust bag
3
2
1
009501
The use of the dust bag makes cutting operations
cleaner and dust collection easier. To attach the dust bag,
fit it onto the dust nozzle.
When the dust bag is about half full, remove the dust bag
from the tool and pull the fastener out. Empty the dust
bag of its contents, tapping it lightly so as to remove
particles adhering to the insides which might hamper
further collection.
NOTE:
If you connect a vacuum cleaner to your saw, cleaner
operations can be performed.
Dust box (Optional accessory)
3
006793
Insert the dust box into the dust nozzle.
Empty the dust box when necessary.
11
1. Hex bolt
1
1. Fastener
2. Dust bag
3. Dust nozzle
1. Dust box
1
2. Cover
3. Button
2