Switch Action; Electric Brake - Makita LS1016 Manual De Instrucciones

Switch action

To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
Before plugging in the tool, always check to
•
see that the switch trigger actuates properly
and returns to the "OFF" position when
released. Do not pull the switch trigger hard
without pressing in the lock-off button. This
can cause switch breakage. Operating a tool with
a switch that does not actuate properly can lead to
loss of control and serious personal injury.
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
009491
WARNING:
Do not use a lock with a shank or cable any
•
smaller than 6.35 mm (1/4") in diameter. A
smaller shank or cable may not properly lock the
tool in the off position and unintentional operation
may occur resulting in serious personal injury.
NEVER use tool without a fully operative
•
switch trigger. Any tool with an inoperative switch
is HIGHLY DANGEROUS and must be repaired
before further usage or serious personal injury may
occur.
For your safety, this tool is equipped with a lock-off
•
button which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off button. A switch in need of repair may result
in unintentional operation and serious personal
injury. Return tool to a Makita service center for
proper repairs BEFORE further usage.
NEVER defeat the lock-off button by taping down or
•
some other means. A switch with a defeated
lock-off button may result in unintentional operation
and serious personal injury.

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop the blade after the
switch trigger is released, have the tool serviced at a
1. Switch trigger
2. Lock-off button
3. Hole for padlock
1
3
2
Makita service center.
CAUTION:
The blade brake system is not a substitute for
•
the blade guard. Never use tool without a
functioning blade guard. An unguarded blade
may result in serious personal injury.
Electronic function
Constant speed control
The tool is provided with an electronic speed
•
control which helps maintain a constant blade
rotation speed even under load. A constant blade
rotation speed will result in a very smooth cut.
Soft start feature
This function allows the smooth start-up of the tool
•
by limiting the start-up torque.
Laser beam action
For model LS1016L only
009492
CAUTION:
LASER RADIATION
•
Do not stare into beam.
To turn on the laser beam, press the upper position (I) of
the switch. To turn off the laser beam, press the lower
position (0) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by adjusting the adjusting screw as
follows.
009493
1. Loosen the adjusting screw by turning it
counterclockwise.
2. With the adjusting screw loosened, slide the
adjusting screw to the right or left as far as it goes.
3. Tighten the adjusting screw firmly at the position
where it stops sliding.
9
1. Switch for laser
1
1. Adjusting screw
1