Adjusting The Miter Angle; Adjusting The Bevel Angle - Makita LS1016 Manual De Instrucciones

stopper arm in the direction of the arrow as shown in the
figure. Adjust the adjusting screw so that the blade stops
at the desired position when lowering the handle fully.

Adjusting the miter angle

3
009517
Push the grip so that the cams engages and turn it
clockwise until it stops. Turn the turn base while pressing
down the lock lever. When you have moved the grip to
the position where the pointer points to the desired angle
on the miter scale, turn the grip 90° counterclockwise to
lock the turn base.
CAUTION:
After changing the miter angle, always secure the
•
turn base by turning the grip 90° counterclockwise.
NOTICE:
When turning the turn base, be sure to raise the
•
handle fully.

Adjusting the bevel angle

To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise. Push the latch lever forward
as shown in the figure fully while supporting the weight of
the saw head so as to release the pressure on the lock
pin.
When tilting the carriage to the right, tilt the carriage to
the left slightly after loosening the lever and press the
releasing button. With the releasing button being pressed,
tilt the carriage to the right.
1
009489
1. Lock lever
2. Grip
1
3. Cam
2
1. Lever
1
010322
Tilt the saw blade until the pointer points to the desired
angle on the bevel scale. Then tighten the lever
clockwise firmly to secure the arm.
4
3
2
1
009513
When the latch lever is pulled towards the front of the
saw, the saw blade can be locked using positive stops
at the right and left 22.5 ° and 33.9 ° angle to the base
surface.
When the latch lever is pushed to the back of the saw as
shown in the figure, the saw blade can be locked at any
desired angle within the specified bevel angle range.
CAUTION:
After changing the bevel angle, always secure the
•
arm by tightening the lever clockwise.
NOTICE:
When tilting the saw blade be sure the handle is
•
fully raised.
When changing bevel angles, be sure to position
•
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
Slide lock adjustment
1
009496
To lock the lower slide pole, pull the lock lever towards
the front of the saw.
To lock the upper slide pole, turn the locking screw
clockwise.
8
1. Latch lever
1. Scale plate
2. Release button
3. Pointer
4. Latch lever
1. Lock lever
2. Locking screw
2