Descargar Imprimir esta página

ABB Emax T7 Guia De Inicio Rapido página 7

Sensor de corriente para conductor neutro externo
Ocultar thumbs Ver también para Emax T7:

Publicidad

L
-
L'orientamento del sensore sul neutro esterno deve essere uguale
all'orientamento dei sensori installati sul CB.
-T
he orientation of the sensor on the external neutral has to be the
same as the orientation of the sensors installed on the CB.
-Der Sensor auf dem externen Neutralleiter muss in derselben Weise
wie die Sensoren auf dem Leistungsschalter ausgerichtet sein.
-L'orientation du capteur sur le neutre extérieur doit être identique à
celle des capteurs installés sur le disjoncteur.
-La orientación del sensor en el neutro exterior debe ser igual a la
orientación de los sensores instalados en el IA.
*S) Lo schermo del cavo di collegamento va messo a terra solo sul lato interruttore. Il collegamento deve essere realizzato con il cavo
ABB fornito; il cavo non può essere interrotto e non è ammesso l'utilizzo di altri cavi ne l'estensione per mezzo di morsettiere intermedie.
*S) The shield of connection cable must be earthed on circuit breaker side only. Make the connection using the ABB cable supplied.
There must be no break in the cable. Use of other cables or extensions using intermediate terminal boxes is not allowed.
*S) Der Schirm des Verbindungskabel darf nur auf der Seite des Leistungsshalters geerdet werden. Der Anschluss ist mit einem vom ABB
gelieferten Kabel mit auszuführen; das Kabel darf nicht unterbrochen werden und es ist unzulässig, andere Kabel zu verwenden
oder es durch zwischengeschaltete Klemmenleisten zu verlängern.
*S) Le blindage du câble de raccordement ne doit être mis à la terre que sur le côté disjoncteur. Le raccordement doit être réalisé
avec le câble ABB fourni; le câble ne peut pas être interrompu et l'utilisation d'autres câbles ni l'extension à travers des borniers
intermédiaires ne sont autorisés.
*S) La pantalla del cable de conexionado debe ser puestaa tierra por el lado del interruptor. Realizar la conexión con el cable ABB
suministrado; no interrumpir el cable y no utilizar otros cables ni extenderlo mediante placas de bornes intermedias.
© Copyright 2006 - 2016 ABB. All rights reserved.
www.abb.com
Example for T7
-T7M
-X1
T7
-T7M-
T8-X1

Publicidad

loading

Este manual también es adecuado para:

Tmaxt7Emax t7mTmaxt7mEmax t8Tmaxt8Emax x1 ... Mostrar todo