Task 2: Mounting Vess R2600 In A Rack - Promise Technology Vess R2000 Serie Guia De Inicio Rapido

TASK 2: MOUNTING Vess R2600 IN A RACK

The instructions here apply to the Vess R2600 and Vess J2600 series.
Cautions
* Do not populate any unit with hard drives until it has been securely installed in
the rack.
* At least two persons are required to safely lift, place, and attach the Vess
R2600 or Vess J2600 unit into a rack system.
* Do not lift or move the Vess R2600 or Vess J2600 unit by the handles, power
supplies or the controller units. Hold the subsystem itself.
* Do not install the Vess R2600 or Vess J2600 unit into a rack without rails to
support the subsystem.
* Only a qualified technician who is familiar with the installation procedure
should mount and install the Vess R2600 or Vess J2600 unit.
* Mount the rails to the rack using the appropriate screws and flange nuts, fully
tightened, at each end of the rail.
* Do not load the rails unless they are installed with screws as instructed.
* The rails available for the PROMISE Vess R2600 or Vess J2600 unit are
designed to safely support that PROMISE Vess R2600 or Vess J2600 unit
when properly installed. Additional loading on the rails is at the customer's risk.
* PROMISE Technology, Inc. cannot guarantee that the mounting rails will
support your PROMISE Vess R2600 or Vess J2600 unit unless you install
them as instructed.
The Vess R2600 or Vess J2600 installs to the rack using the mounting rails shipped with the device.
Note
To lighten the Vess R2600 or Vess J2600 enclosure, you can remove the power
supplies. Replace the power supplies after the Vess R2600 or Vess J2600 unit is
mounted in your rack.
All manuals and user guides at all-guides.com
10