DeWalt DCN660 Manual De Instrucciones página 12

MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and disconnect it from power
source before installing and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
Daily Maintenance Chart
ACTION Clean magazine, pusher, and contact trip mechanism.
WHY Permits smooth operation of magazine, reduces wear, and prevents jams.
HOW The use of oils, lubricants periodically or solvents is not recommended as they tend to
attract debris.
ACTION Before each use, check to insure all screws, nuts and fasteners are tight and undamaged.
WHY Prevents jams and premature failure of tool parts.
HOW Tighten loose screws or other fasteners using the appropriate Allen wrench or
screwdriver.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week.
To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when
performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use
a cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning.
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-
metallic brush. Do not use water or any cleaning solutions.
Lubrication
WARNING: NEVER spray or in any other way apply lubricants or
cleaning solvents inside the tool. This can seriously affect the life and
performance of the tool.
D WALT tools are properly lubricated at the factory and are ready for use.
e
However, it is recommended that, once a year, you take or send the tool
to a certified service center for a thorough cleaning and inspection.
Accessories
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous. To
reduce the risk of injury, only D WALT recommended accessories should be used with this
e
product.
Recommended accessories for use with your tool are available at extra cost from your local
dealer or authorized service center. If you need assistance in locating any accessory, please
contact D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call
e
1-800-4-D WALT (1-800-433-9258) or visit our website: www.dewalt.com.
e
Repairs
WARNING: To reduce the risk of serious personal injury, remove nails from magazine
before making any adjustments or servicing this tool.
The charger and battery pack are not serviceable.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including
brush inspection and replacement) should be performed by a D
center, a D WALT authorized service center or other qualified service personnel. Always use
e
identical replacement parts. Refer to the Troubleshooting Guide at the end of this section.
Register Online
Thank you for your purchase. Register your product now for:
• WARRANTY SERVICE: Registering your product will help you obtain more efficient
warranty service in case there is a problem with your product.
• CONFIRMATION OF OWNERSHIP: In case of an insurance loss, such as fire, flood or
theft, your registration of ownership will serve as your proof of purchase.
• FOR YOUR SAFETY: Registering your product will allow us to contact you in the
unlikely event a safety notification is required under the Federal Consumer Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty materials or workmanship for
e
three years from the date of purchase. This warranty does not cover part failure due to normal
wear or tool abuse. For further detail of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
apply to accessories or damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may have other rights which
vary in certain states or provinces.
In addition to the warranty, D
D WALT will maintain the tool and replace worn parts caused by normal use, for free, any
e
time during the first year after purchase. Excludes wear components (Driver blade ,profile,
rails, springs, bumpers).
DC9071, DC9091, DC9096, DC9280, DC9360, DC9180, DCB120, DCB201 and
Product warranty voided if the battery pack is tampered with in any way. D
responsible for any injury caused by tampering and may prosecute warranty fraud to the
fullest extent permitted by law.
No Lube
If you are not completely satisfied with the performance of your D
WALT, have not been or Nailer for any reason, you can return it within 90 days from the date of purchase with a
e
receipt for a full refund – no questions asked.
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For
products sold in Latin America, see country specific warranty information contained in the
packaging, call the local company or see website for warranty information.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-4-D
WALT factory service
e
10
WALT (1-800-433-9258). This warranty does not
e
WALT tools are covered by our:
e
1 YEAR FREE SERVICE
2 YEARS FREE SERVICE ON D WALT BATTERY PACKS
e
DCB203
3 YEARS FREE SERVICE ON D WALT BATTERY PACKS
e
DCB200, DCB204
D WALT BATTERY PACKS
e
90 DAY MONEY BACK GUARANTEE
WALT (1-800-433-9258) for a free replacement.
e
WALT is not
e
WALT Power Tool, Laser,
e