Alarms Screen - Selco Genesis 284 PSR Instrucciones De Uso

7 Warning limits line
8 Alarm limits line
9 Minimum levels column
10 Maximum levels column
Select the required box by pressing the encoder key (the select-
ed box is displayed with reverse contrast).
Adjust the level of the selected limit by rotating the encoder.
Save and exit the current screen by pressing button (3)
Passing one of the warning limits causes a visual signal to appear
on the control panel.
Passing one of the alarm limits causes a visual signal to appear
on the control panel and the immediate blockage of the weld-
ing operations.
It is possible to set start and end of welding filters to prevent
error signals during the striking and extinction of the arc (consult
the "Set up" section - Parameters 38 and 39).

3.14 Alarms screen

Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E00 General alarm
E01 Temperature alarm
E04 Communication alarm (PSR)
E05 Current too high alarm
E07 Wire feed motor supply alarm
42
All manuals and user guides at all-guides.com
E08
E10
E11
.
E12
E13
E14
E16
E20
E21
E22
E23
E24
E25
E26
E40
E41
E42
E43
E44
E49
E51
E52
Blocked motor alarm
Power module alarm
System configuration alarm
Communication alarm (WF - PSR)
Communication alarm (RC 300 - PSR)
Program not valid alarm
Communication alarm (RI)
Memory fault alarm (PSR)
Data loss alarm (PSR)
LCD display alarm
Memory fault alarm (RC)
Data loss alarm (RC)
Memory fault alarm (WF)
Data loss alarm (WF)
System power supply alarm
Overvoltage alarm
Undervoltage alarm
Coolant shortage alarm
Gas shortage alarm
Emergency switch alarm
Unsupported settings alarm
Anti-collision alarm