Using the Buckle
Using the Buckle
Follow the steps below to unlatch or latch the case.
Unlatching the Case
Unlatching the Case
q
w
Keeping the buckle release button pressed (
), open the buckle (
) and
e
then open the rear cover (
).
En
Latching the Case
Latching the Case
q
w
Close the case (
) and fl ip the buckle onto the front half (
), then press
e
the buckle closed until it clicks into place (
). Check that the case is
properly sealed, that the O-ring is in place, and that no foreign objects are
0
caught in the seal (
23).
D
Opening the Case
Before opening the case, be sure it is completely dry and free of dirt. After using the case
underwater, wash it in fresh water to remove any sand or other foreign objects and then dry
it thoroughly with a soft, dry cloth. Be sure that any water, sand, or other foreign objects left
on the case do not fall into the interior when the case is opened. Never operate the buckle or
buckle release button underwater.
Be careful not to drop the camera when removing it from the case.
4