Toro 38701 Manual De Instrucciones página 27

3. Manually pull the power unit rearward to remove
the broom assembly from the machine.
4. Support the spline shaft on either side of the
gearbox.
5. Stand the broom core assembly on end so that
the end retainer plate faces upward
Figure 38
1. Hardware
2. End-retainer plate
3. Broom segment
6. Remove and retain the hardware from the
end-retainer plate
7. Remove the damaged broom segment(s).
8. Install the new segment(s) by staggering the
metal ring alignment fingers as shown in
38.
Important:
You may damage the broom
assembly if you do not properly install the
broom segments.
9. Install the broom assembly onto the machine.
Important:
Make sure that the bearing
setscrews are tightened before operating the
broom.
(Figure
4. Support shaft
5. Alignment fingers
(Figure 38).
Checking the Broom Drive
Adjustment
Service Interval: After the first 2 hours—Check the
38).
Yearly—Check the broom drive adjustment and
correct it if necessary.
1. Remove the belt cover; refer to
Belt Cover (page
2. With the broom drive lever disengaged, ensure
that the gap between the broom clutch arm and
the frame of the machine is 1.5 mm (1/16 inch)
as shown in
Important:
clutch arm and the frame is too small or too
large, adjust the broom drive cable; refer to
Adjusting the Broom Drive Cable (page
g326889
Figure
1. 1.5 mm (1/16 inch) gap
2. Frame
3. If the gap between the broom clutch arm and
the frame is 1.5 mm (1/16 inch), install the belt
cover; refer to
26).
25
broom drive adjustment and correct
it if necessary.
Removing the
26).
Figure 39.
If the gap between the broom
Figure 39
3. Broom clutch arm
Installing the Belt Cover (page
26).
g326890