Belt Maintenance - Toro 38701 Manual De Instrucciones

Adjusting the Broom Drive Cable
1. Loosen the jam nut
Figure 40
1. Adjuster tube
2. Jam nut
2. Rotate the spring-tension adjuster until you
measure a 1.5 mm (1/16 inch) gap between the
frame and the broom clutch arm (
Figure 41).
Figure 41
1. 1.5 mm (1/16 inch) gap
2. Frame
3. Tighten the jam nut
4. Install the belt cover; refer to
Cover (page 26).
Important:
If the broom cable is properly adjusted
but a problem remains, contact your Authorized
Service Dealer.
(Figure 40).
3. Spring-tension adjuster
4. Spring
Figure 40
3. Broom clutch arm
(Figure 40).
Installing the Belt

Belt Maintenance

Removing the Belt Cover
1. Loosen the 2 flange-head screws that secure
the belt cover to the machine
g325107
1. Screw
and
2. Remove the cover from the machine.
Installing the Belt Cover
1. Align the slots in the belt cover with the 2
flange-head screws
g326890
2. Assemble the belt cover onto the machine
(Figure 43).
3. Tighten the flange-head screws.
26
(Figure 42).
Figure 42
2. Belt cover
(Figure 43).
Figure 43
g325103
g325103