Product Overview; Controls - Toro 38701 Manual De Instrucciones

Product Overview

1. Wheel-clutch lever
2. Broom-angle lever
3. Broom-drive lever
4. Speed-selector lever
5. Hand bar grip

Controls

Determine the left and right sides of the machine from
the normal operating position.
Choke Control
The choke control is the top lever located on the rear,
left side of the engine above the fuel-shutoff valve
(Figure 5).
The choke is used to aid in starting a cold engine.
Move the lever left to the O
Do not run a warm engine with the choke in the O
position.
Figure 4
6. Traction-drive lever
7. Fuel-tank cap
8. Broom and hood
9. Broom-height-adjustment
pin
position for a cold start.
N
1. Choke control
g325102
2. Fuel-shutoff valve
3. Throttle control
Fuel-Shutoff Valve
Use the fuel-shutoff valve to shut off the fuel when
you will not use the machine for a few days, park the
machine inside a building, or transport the machine to
and from the job site
Move the lever to the left to shut off the fuel. Move the
lever to the right to turn on the fuel.
Throttle Control
The throttle control is located on the rear, right side of
the engine and below the fuel tank
The throttle is used to control engine speed. Moving
the throttle control to the left increases the engine
speed, and moving it right decreases the engine
speed.
N
Engine On/Off Switch
Located on the right side of the engine
Rotate the switch clockwise to the O
before starting the engine. Rotate the switch
counterclockwise to the O
engine.
7
Figure 5
4. Recoil-start handle
5. Engine On/Off switch
(Figure 5).
(Figure 5).
(Figure
position
N
position to shot off the
FF
g326826
5).