Skoda BFC 400 001 Instrucciones De Montaje página 19

- Click the second end of the linkage (G
- 7 -
- Loosen the bushing and the front door set holder clamp -arrows-.
- Feed the wire from the motor (A
installation until it reaches the opening on the side of the door.
- Secure the wire to the clamps for the existing door electrical installation.
- Secure the wire to the existing vehicle electrical installation directly behind the clamp
using the fastening tape (H) -detail-.
- 8 -
- Feed the wire through the flexible bushing -arrow- and connect it to the enclosed white
terminal box (hollow) (I) according to the diagram. Secure the threaded wire.
- 9 -
- Thread the linkage (J
re.
- Thread the rear door lock linkage through the eye at the other end of the linkage (J
and reconnect the linkage to the crank lever.
- 10 -
- Thread the rear door motor wire (B
in the set holder up to the opening on the side of the door.
- Place the bushing in the opening in the set holder and lightly clamp the wire -detail-.
- 11 -
- Thread the wire through the flexible bushing (S) and connect it to the enclosed blue terminal
box (hollow) (L) according to the diagram. Secure the threaded wire.
- Click the wiring cover into the flexible bushing -arrow- and place it back in the opening in
the side of the rear door.
- Click the terminal box holder (M) into the opening in the centre column -detail-.
- 12 -
- Wire the central locking electrical installation cable bundle (N) according to the picture.
- In the A-column on the driver' s side, there must be a 6-pole T6j terminal box with 5 wires
attached. On the passenger' s side, have T6k only 4 wires are attached.
- Lead the earthing wire (brown with an eye) along the left-hand side of the vehicle up to the
earthing point on the left rear fender apron.
- The entire electrical installation should follow the vehicle electrical installation. Fasten it at
suitable points using the supplied fastening tape (H) -detail-.
- 13 -
- Fasten the brown wire from the cable bundle under the earthing screw on the left-hand rear
wheel housing -detail-. Use the OK 10 socket wrench.
) to the linkage end piece -arrow-.
1
) through the bushing concurrently with the door electrical
1
) through the rear door motor suspension eye according to the pictu-
1
) through the bushing (K), and then through the opening
1
GB
) -detail-
1