Quinny XL FREESTYLE Modo De Empleo/Garantia página 20

Removing the wheels
- To disassemble the rear wheels, press the button on the hubcap (5/8) and pull the wheel out of the axle
opening (9).
Adjusting the handlebar
- To adjust the height of the handlebar, push the release buttons at the same time (4.1) and rotate the
handlebar into the desired position (4.2).
Folding
- Fold up the sun canopy (see "Attaching/removing sun canopy").
- Place the back of the pushchair seat in the reclining position (see "Adjusting the back").
- Place the footrest in the highest position (see "Footrest").
- Tilt up the fold lock above the right handlebar safety lock (10).
- Pull the left and right handlebar safety lock upwards and push the handlebar forward until the Freestyle 4 XL
is folded (11).
- Make sure that the handlebar safety lock "clicks" into the transport safety lock (12).
- Remove the wheels and pushchair seat (see "Attaching pushchair seat") to make the pushchair even smaller.
PARKING BRAKE (see illustration 13)
- Always use the brake when parking the Freestyle 4 XL, "also when at a standstill".
- Step on the pedal on the rear axle to lock the wheels (13).
- Release the parking brake by pulling the pedal upward.
- The handbrake is for slowing down and should not be used as a parking brake. The handbrake works on both
rear wheels. If you squeeze the handbrake too firmly or quickly, there is a risk that you will stumble over the
Freestyle 4 XL, thus endangering your child.
- Always check whether the wheels are locked.
INSTRUCTIONS FOR USE
For use with the Dreami carrycot (up to 9 kg)
and the Maxi-Cosi car safety seat (up to 13 kg) (see illustrations 14 - 20)
Attaching the adapters
- First remove the guards by moving the red button under the adapter connections outward while pushing the
guards upward (14).
- Slide the adapter marked A into the right-hand side and the adapter marked B into the left-hand side of the
adapter attachment.
- Continue sliding until you hear a "click" (15).
- Check to make sure the adapters are secure.
Placing the Dreami carrycot
- Unfold the pushchair and place the carrycot onto the adapters with the foot end between the sides of the
handle (16).
- Check to make sure the carrycot is fastened securely.
Removing the Dreami carrycot
- Place your thumbs on the control buttons on both sides of the carrycot (17.1).
- Push in the buttons while lifting the carry cot from the Freestyle 4 XL (17.2).
Fitting the Maxi-Cosi car seat
- Unfold the pushchair and place the car safety seat onto the adapters with the foot end between the sides of
the handle (18).
- Check to make sure the car seat is fastened securely.
All manuals and user guides at all-guides.com
GB
19