Publicidad
4b
Install the inside assembly on the inside of the door.
Bolt must remain retracted!
Guide the tailpiece
into the slot.
4c
Secure the inside assembly with two screws.
L If the screw holes are blocked by the cam, see step 4a.
4d
Connect the cable to the inside assembly.
The connector fits only one way.
DO NOT FORCE!
4e
Install the batteries.
CAUTION
Route the cable
through the hole in
the inside assembly.
Actual Size (2)
CAUTION
Red wire
4f
Install the inside cover.
Align the slot with
the tailpiece.
4g
Secure the inside cover with two screws.
5
Test the Lock
Extend and then retract the bolt using the inside bolt throw.
Bolt should extend and
retract smoothly.
L Outside bolt throw should spin freely until a valid
credential is presented.
6
Set up the lock.
Access online interactive
instructions, user guide,
warranty, and reference
information.
alle.co/control
Customer Service
1-877-671-7011
Thumbturn should be
pointed towards hinges,
with longer side on top.
Actual Size (2)
www.allegion.com/us
© Allegion 2020
Printed in U.S.A.
47327849 Rev. 10/20-a
Publicidad
