Publicidad
Indicator
options:
Thumb turn
1
Remove armor front.
2
Remove cylinder(s) or thumb turn if applicable.
2a
Loosen the cylinder mounting screw.
Customer Service
1-877-671-7011
www.allegion.com/us
INDICATOR LOCK RETROFIT INSTRUCTIONS
Cylinder
2b
Remove the outside cylinder, if applicable.
Insert the key halfway into the cylinder and rotate
cylinder counterclockwise to remove.
2c
Repeat for the inside cylinder, if applicable.
2d
Remove inside turn, if applicable.
Rotate 90°
Extend
deadbolt
3
Check door preparation.
IMPORTANT
•
To install the indicator trim, additional door preparation
may be required. If additional door preparation is required,
remove the lock chassis from the door before drilling. Steps
for reassembly are included in this instruction sheet.
•
Please refer to the template included in this package.
•
Make sure the door is prepared with any necessary holes for
the indicator trim.
4
Complete installation of indicator trim.
Go to STEP 2 ON PAGE 2 and follow the instructions to
complete the installation of the indicator trim.
Key inserted
halfway
© Allegion 2018
Printed in U.S.A.
P516-911 Rev. 11/18-d
Publicidad
