Door Shelves; Adjustable Door Shelf; Glass Shelves - Beko BBBF3019IMWESS Manual Del Usuario

Operating the Product

5.20 Door Shelves

To remove a door shelf, hold the shelf from the
lower section, lift it and slide it outwards. Please
see the figure.
C
If opening the door is limited with
90°, you may have to remove the
door shelves before removing a
storage drawer or glass shelf.

5.21 Adjustable Door Shelf

(May not be available in all models)
Press and hold the buttons at the right and
left-hand sides to adjust the door shelf to the
desired position without having to remove it. To
remove the adjustable door shelf, press and hold
the buttons, lift the shelf completely and pull it
towards yourself. To install the door shelf back, put
it into its place on the door and slide it downwards
by pressing the buttons. Please see the figure.

5.22 Glass Shelves

(May not be available in all models)
Height of the glass shelves on your product can be
adjusted manually or with rear hangers.
Please follow the instructions below to remove,
install and adjust a glass shelf.
A
ATTENTION:
Glass shelves must be unloaded.
1. Hold the shelves with rear hangers as shown
below. Your hands must be at the rear section.
Make sure you are holding the shelf tightly from
the bottom.
2. Lift the front section of the glass shelf as shown
below and bring it to an angled position.
3. Once it is angled, tabs on the hangers will be
released and the glass shelf will move up and down.
Thus you can adjust the position.
4. To remove the glass shelf, bring it to the maximum
height and pull towards yourself.
5. To install the glass shelf, place the pins at the rear
corner of the shelf into the slots through the gap at
the top and slide it downwards in an angled manner.
28 / 35 EN
Refrigerator / User Manual