GE PFMS1FFB Manual De Uso Y Cuidado página 62

INSTALLING THE REFRIGERATOR
REMOVE THE FRESH FOOD
6
DOOR HANDLE
(For placement in the installation location or
reversal of the handles – on some models)
Stainless steel (on some models):
REMOVING
A
THE DOOR HANDLE:
Loosen the set screws
with the 3/32" Allen
wrench
and remove
the handle. NOTE: For
Double Door models
follow the same
procedure on the
opposite door.
Plastic handle (on some models):
REMOVING THE DOOR HANDLE: Depress the tab on
A
the underside of the handle and slide the handle up
and off of the mounting fasteners.
REVERSING THE DOOR HANDLE (on some models):
• Remove
the handle
mounting
fasteners with
a 1/4" Allen
wrench and
transfer the
handle
mounting
fasteners to the
right side.
• Remove the
logo badge.
• Remove and
transfer the
plug button to
the left side of the fresh food door. NOTE: Use a flat
plastic edge to prevent damaging the door. Remove
any adhesive on the door with a mild detergent.
Remove the paper covering on the adhesive
backing on the logo badge prior to carefully
attaching the badge to the door.
60
Installation Instructions
A
B
Mounting
Fasteners
(appearance may vary)
B
A
Mounting
Fasteners
(appearance may vary)
(cont.)
REMOVE THE FREEZER DOOR HANDLE
7
Stainless steel and plastic handles:
Loosen the set screws located on the underside of
A
the handle with a 1/8" or 3/32" Allen wrench and
remove the handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4" Allen wrench.
Badge
(appearance may vary)
Handle with support
1. Push up/right handle, until feel
unlock
Badge
2. Continue slide the handle until
support had been free from washer.
3. Take off handle from door.
A
A
A
(appearance may vary)