Replacing The Light Bulbs; Refrigerator Lights - GE PFMS1FFB Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing the light bulbs.

Turning the control to the 0 (off) position does not remove power to the light circuit.
Light
Shield
Appearance may vary
54

Refrigerator Lights

(on some models)
CAUTION:
Light bulbs may
be hot.
Unplug the refrigerator.
To remove the light shield, grasp the
shield at the back and pull out to release
the tabs at the back.
Rotate the shield down and then forward
to release the tabs at the front of the
shield.
LED Lighting – Module (on some models)
LED Lighting – Individual (on some models)
LED lighting will need to be replaced by an
authorized technician.
Call 1.800.432.2737 in the United States. In
Canada, call 1.800.561.3344
Freezer Light (on some models)
CAUTION:
be hot.
Unplug the refrigerator.
Remove the freezer basket for access.
The bulb is located at the rear of the
freezer inside a light shield.
To remove, grasp the shield at the top
and pull out to release the tabs at the
bottom.
After replacing with an appliance bulb of
the same or lower wattage, replace the
shield.
Plug the refrigerator back in.
NOTE: Appliance bulbs may be ordered from
GE Parts and Accessories, 800.626.2002.
Note: Some models have led illumination. Call to the
service center to request led lamp replacement or you
can replace them with incandescent light bulbs of
maximum 60 watts for refrigerator, maximum 40 watts
for freezer, and nominal voltage.
Light bulbs may
After replacing with an appliance bulb of
the same or lower wattage, replace the
shield and freezer basket.
Plug the refrigerator back in.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido