Adjusting The Drag Stake; Operating Tips - Toro 58601 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 14
1. Locking sleeve—locked
position

Adjusting the Drag Stake

The drag stake helps regulate cultivating depth and
prevents the cultivator from jerking forward during
operation. Set the drag stake in the lowest position
to increase resistance to forward motion and to dig
deeper.
1.
Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2.
Remove the lock pin.
3.
Position the drag stake to the desired depth with
the tip pointing downward.
4.
Secure the drag stake with the lock pin.
Figure 15
1. Lock pin
g334239
2. Locking sleeve—unlocked
position
g334215
2. Drag stake

Operating Tips

Inspect the area where you will use the cultivator
and remove all objects such as large rocks,
trash, and branches before cultivating to prevent
equipment damage.
The clutch transfers maximum power after about
2 hours of normal operation. During this break-in
period, the clutch may slip. Keep the clutch free of
oil and other moisture for efficient operation.
Always begin cultivating with the slowest ground
speed possible. Increase the speed if conditions
permit.
Do not place excessive body weight on the
cultivator. Use the weight of the machine to
cultivate more efficiently.
13

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido