Safety Notes; Important Notes; Functions; Information About Operation - LGB 99 5016 Manual De Instrucciones

Safety Notes

• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product specifies the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
• Factory-installed multiple protocol decoder (DC, DCC, mfx).
• The model is programmed with locomotive address 03 for use with the LGB Multi
Train System (DCC). The locomotive is automatically recognized in operation with mfx.
• Volume can be changed for the sound effects
• Mfx technology for the Mobile Station/Central Station.
Name set at the factory: 99 5016
• The functions can be activated only in parallel. Serial activation of the functions is
not possible (Please note here the instructions for your controller).
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
Mode of Operation Switch
There is a three-position mode of operation switch in the locomotive's cab (Figure 1).
Pos. 0 Locomotive stopped, without power
Pos. 1 Locomotive motors, smoke unit, and lighting on
Pos. 2 Same as Position 1
General-Purpose Socket
There is a general-purpose socket for flat plugs on the back wall of the locomotive
cab (Figure 2). You can connect LGB cars with lighting or with sound circuits to the
track voltage by means of this socket.
Smoke Unit
This model comes with a smoke unit. A test package with LGB smoke and cleaning
fluid is included. Fill the smoke stack halfway with this fluid. If too much fluid is put in,
the smoke unit cannot produce smoke.
8