dirna Bergstrom bycool green line LITE RENAULT T Instrucciones De Montaje página 16

LITE
EN
Lifting the equipment, position the supports
8
on the studs above the upholstery, inserting
an L=6 mm spacer between the support and
the nut of the stud, and secure with (4) Ø8
flat washers and (4) M8/125 self-locking nuts,
without tightening.
Position the console and align the unit where
9
the original was located and remove the
console.
Caution: Once the unit is aligned, it is very
important to check on the inside that the air
input grilles of the condenser are not inside
the seal, in order to ensure water does not
enter the cabin through them.
Tighten the nuts of the supports until they
10
come up against the spacers with the top nuts
of the studs.
10
Spacer 6mm
8
8
9
10
16
®