Stanley SCL-D Manual De Instrucciones página 10

Batteries and Power
Battery Installation / Removal (See figure
Laser Tool
• Turn laser tool to battery door and open.
• Install / Remove batteries. Orient batteries correctly
when placing into battery compartment.
• Close battery door. Be sure that the door has been
closed securely.
WARNING:
• Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
10 FMHT77321
All manuals and user guides at all-guides.com
Set Up
) Laser Tool
B
Mounting on Accessories
NOTE:
• It is best practice to always support laser tool with
• If positioning over a target, partially tighten the fastening
• Place laser tool on a flat, stable surface.
• If using the auto levelling feature move the pendulum
/ transport lock to the unlocked position. The laser tool
must then be positioned in its upright position on a
surface that is within the specified compensation range.
• Position accessory in a place where it will not be easily
disturbed and near the central location of the area to
be measured.
• Set up the accessory as required. Adjust positioning to
be sure accessory base is near horizontal (within laser
tools compensation range).
• Mount the laser tool to the accessory using the
appropriate fastening method to be used with such
accessory / laser tool combination.
CAUTION:
• Do not leave the laser tool unattended on an
accessory without fully tightening the fastening
screw. Failing to do so may lead to the laser tool
falling and sustaining possible damage.
one hand when placing or removing laser tool from an
accessory.
screw, align laser tool, and then fully tighten.