Manual Mode; Master/Slave Mode - NEO PROTON IP QW ZOOM Manual De Usuario

All manuals and user guides at all-guides.com
• Set the colors R , G , B, W, GB, RB, RG, ,RGB, RW, GW, BW,
RGW, RBW, GBW, RGBW, through the buttons UP/DOWN,
then press the button ENTER.
• Press the MENU button to go back or to meet the waiting
time to exit the setup menu.

Manual mode

This mode allows to combine the colors red, green, blue
and white (R, G, B, W).
• Press the button MENU so many times until the display
shows Static, then press the button ENTER. • Select Man-
ual Color through the buttons UP/DOWN, then press the
button ENTER.
• Select the color R, G, B, W through the buttons UP/
DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color R, G, B,. W.
• Continue until the desired mix is obtained.
• Press the MENU button to go back to the main menu.

Master/slave mode

This mode will allow you to link up the units together with-
out a controller. Choose a unit to function as the Master.
The unit must be the firast unit in line; other units will work
as slave.
• Use standard DMX cables to daisy chain your units to-
gether via the DMX connector on the rear of the units. For
longer cable runs we suggest a terminator at the last fixture.
• Set on master fixture the desired program.
• Set the slaves to the same DMX modes.
Linkung
• Connect the DMX OUT of the master unit via 5-pin XLR
cable to the DMX IN of the first slave unit.
• Connect the DMX OUT of the first slave unit to the DMX
P. 11
PROTON IP QW ZOOM
ENGLISH VERSION