Traxxas SLASH 4x4 ULTIMATE Instrucciones Para El Inicio Rápido página 11

using the high-speed pinion, download the complete manual. The
complete manual for your model can be viewed and downloaded by
following the link on the cover of this manual, or by scanning the QR
code. Please read this entire manual for complete instructions on the
proper use and maintenance of your model.
The TQi ™ Docking Base is a powerful accessory that allows your
Apple ® iPhone ® or iPod touch ® to access the many tuning and setup
adjustments built into the TQi transmitter. To experience all the
features of the TQi with Docking Base, you will need an Apple iPhone
(3G, 3GS, 4, 4S) or iPod touch (2nd generation and later versions). You
will also need the Traxxas Link ® application, which you can download
from the Apple App Store . The App Store may be selected on your
™
iPhone or iPod touch with internet access, or downloaded from iTunes.
The customizable Traxxas Link
dashboard delivers real-time rpm, speed,
temperature, and voltage data.
Installing Your Mobile Device
The TQi Docking Base has a unique clamping mechanism that
™
allows the Apple ® iPhone ® and iPod touch
removed. The clamp's self-adjusting design allows it to accommodate
the wide variety of protective cases available for Apple products.
Follow these steps to install your mobile device:
1. Swing the Docking Base Clamp
lever from position A (locked) to
position B (unlocked).
2. Install your mobile device by
sliding it onto the connector.
3. Ensure your mobile device is
parallel with the Docking Base.
Slide the included foam
pads beneath the mobile
device so it is held parallel
with the docking base
when supported by the
pads. Peel the backing
from the pads and stick
them in place.
4. Close the Docking Base
Clamp by moving it to
position A. Confirm your
mobile device is snug and
securely held in place.
Optional: The Docking Base
Clamp's 'fingers' have soft
gripper pads on them to hold un-cased devices. If your device is
in a soft rubber case, the gripper pads may be removed for easier
device installation and removal.
All manuals and user guides at all-guides.com
Tap and slide to adjust Steering Sensitivity,
Throttle Trim, Braking Percent, and more!
® to be easily installed and
A B
Turn the model off
Press and release the EZ-Set button on the speed control.
The speed control's LED will go out.
Unplug the battery and remove it from the model
Do not store the model with the battery installed.
Turn the transmitter off
Always turn the transmitter off last, after the model has been
turned off.
1
®
Turn off the model. Unplug in the battery.
QUICK START GUIDE
2 3
Always turn your
transmitter off last.
TRAXXAS 11