Generator Connections - Generac 0059151 Directrices De Instalación

3. Mount the connection box so that it completely covers the hole in
the wall. Caulk around the sides and top of the box to ensure a good
seal.
Connect all wires to the lugs in the connection box (black to black,
red to red and white to white). Attach the green ground wire to
the ground screw and connect the two small plugs to their mating
receptacle ends.
4. Replace the protective cover plate and retaining screw, and
lock the connection box.
5. Locate the metal hasp that is packaged in the owner's manual
bag. Insert the hasp in the slot located on the left side of the
external circuit breaker box. Be sure that the clip of the hasp
is facing toward the front of the generator. If desired, lock the
external box.
This circuit breaker may be classified as the disconnect circuit
for the generator. Check local codes for locking and/or lockout
procedures.
NOTE:

GENERATOR CONNECTIONS

This generator comes wired for 220 VAC, no neutral applica-
tions.
1. Remove the screws securing the connection area cover, and
remove the cover.
2. Feed the wires through the back of the generator and secure
the conduit.
3. Run the power leads through a cable tie or some other strain
relief.
General Information
NOTE:
7