Nolan X-lite X-902 Instrucciones De Utilizacion página 21

Scratch Resistant Racing Visor - LEXAN
resistant flat visor with variable thickness
1
2
adherence to the porthole edge.
Warning !
minimum open position (see 1.1.1), first rotate it upwards to the
middle position, then pull it downwards until it automatically
closes.
1.1 - Pulling up the visor
Follow these instructions to pull up the visor:
1.1.1 - Lift the red opening lever on the helmet
chin guard. (fig. 1)
The visor moves forward and outwards along
its sides (fig. 2), until it automatically sets to the
minimum opening position.
Warning !
cle is stopped or moves at low speed, since it
facilitates ventilation and demisting.
1.1.2 - Pull up the visor to the middle opening
position.
1.1.3 - Pull it up again up to the full opening
position.
1.2 - Pulling down the visor
When the visor is in the middle or full open
position, follow the instructions below to pull it
down:
1.2.1 - Lower the visor to the first opening
position; the visor will be automatically reposi-
tioned to the full closing position with perfect
To reclose automatically the visor when it is in the
Keep this position when the vehi-
- 19 -
®
scratch