Nolan X-lite X-902 Instrucciones De Utilizacion página 31

2.4 - Inner comfort padding fitting
Repeat the procedures from point 2.1.6 to 2.1.1 to refit the inner
comfort padding:
2.4.2 - Correctly insert the inner comfort padding in the helmet.
2.4.3 - Fit the left chin strap through the slot of the left cheek pad
(fig. 17); repeat the same procedure on the other side.
2.4.4 - Insert the rear left and right tabs of the inner padding into
the corresponding frames in the neck area (fig. 16). Slightly deform
the edge seal of the shell and push until the pawls snaps.
2.4.5 - Insert the lower left and right tabs of the cheek pads into
the corresponding frames in the cheek pad area inside the helmet
(fig. 15), by slightly deforming the edge seal of the shell and push-
ing the comfort padding inside the helmet.
2.4.6 - Insert the front fastening tabs in the visor area into the sup-
port of the inner shell, by slightly pushing the liner towards inside
the helmet (fig. 14).
2.4.7 - Push one of the cheek pads inside the helmet at the height
of the three rear snap buttons. Repeat the same with the other
cheek pad (fig.13).
WARNING ! If the helmet is equipped with "D-Rings" reten-
tion system, close it as shown in the "D-Rings" instruction
leaflet attached.
- 29 -