Nolan X-lite X-902 Instrucciones De Utilizacion página 23

While using the helmet or after replacing the visor, should this be
not correctly realigned with the shell edge while closing, proceed
as follows:
1) pull the red lever on the helmet chin guard and pull up the
visor completely.
2) With red visor opening lever pulled upwards, set the adjusters
so that the release levers are moved upwards (see fig. 4a).
4a
1 2
4) close the visor and make sure that it correctly fits with the shell
edge. If this is not the case, repeat steps 1, 2 and 3.
Warning !
aligned. It is important that the adjusting arrow 1 is not below the
adjusting arrow 2.
While adjusting the arrows may even not be
3) As a further check rotate the
visor slightly downwards
and move the adjusters until
the release levers set as in
fig. 3. Pull up the red open-
ing lever and then release it
by making sure that the
release levers set back to
position shown in fig. 3.
- 21 -