Warranty; Safety Precautions; Precautions; Results Of The Tests Made By Law - CAMPAGNOLA C2 Manual De Uso Y Mantenimiento

1 - INTRODUCTION

1.5 Warranty

• The tools and machines manufactured by CAMPAGNOLA S.r.l. are guaranteed for 1 or 2 years, depending on the kind of
product, starting from their purchase date indicated in the invoice or in any other document with legal value.
• The warranty is to be considered valid only if the installation and use of the compressor and/or tools have been carried out
according to the instructions indicated in the Use and Maintenance Manual or the written instructions by the Authorized
Service Points personnel.
• Originally damaged or faulty parts will be repaired or replaced free of charge.
• The purchaser shall pay for the labour and transport costs.
• All the parts subject to wear (belts, filters, blades, seals, etc.) are not subject to the warranty
• The eventual costs of intervention performed by the Company's personnel (inspections, disassembling and assembling
operations) caused by a wrong working, not due to manufacture faults, are not included in the warranty.
• Replacements or repairs of faulty equipment, when warranty is claimed by users, can only be authorized by accredited
Service Points personnel and their decision is final.
• The Company shall not be held responsible for any injury or damage caused to people, animals or things, due to improper
use or maintenance of the compressor and/or tools. The warranty is limited to the manufacture defects.
• The warranty is lost in case of tampering and /or even small changes and in case of use of non-original spare parts.
• In any case the replacement of the tool is excluded.
WARNING!
When asking for a repair in warranty, according to the points mentioned above, it is necessary to enclose the warranty
card, properly filled in, and the corresponding proof of purchase with date of purchase (invoice or any other document
with legal value).
2

- SAFETY PRECAUTIONS

2.1 Precautions

WARNING!
The manufacturer declines all responsibilities if the precautions below are not taken.

2.1.1 Results of the tests made by law

WARNING!
Risks due to the operator's contact with the noise and vibrations of the machine or tool.
1)

NOISE LEVEL

Continuous sound pressure level A in the working place, measured according to the UNI EN ISO 3744 regulations:
The levels measured at the various auxiliary equipment are high as they exceed the set reference limit LpA
The following obligations have to be fulfilled:
• The operator shall undergo a periodic check up.
• The operator must be informed of the risks faced caused by exposure to high noise levels.
• Safe and adequate sound barriers or other hearing protection must be used.
2) VIBRATIONS LEVEL
Average weighted hand-transmitted vibration value, in frequency, the user is exposed to measured in compliance
with EN ISO 5349/1-2:
The resulting values, according to the auxiliary tools which have been used, have turned out to be high, since they
overcome the reference limit of 2.5 m/s
• The operator shall undergo a periodic check up.
• The operator shall be informed about the vibrations risks.
• The tool can be used continuously no more than 6 hours per day.
LpA = 88 dBA
eq
2
a = 4.08 m/s
heq
2 . The following obligations have to be fulfilled:
= 70 dBA.
eq
15 - 52