Operating The Tool; Control Devices; Operating Instructions; Trouble-Shooting - CAMPAGNOLA C2 Manual De Uso Y Mantenimiento

4 - INSTALLATION
WARNING!
Before starting working, wear safety helmet, protective glasses and shoes, noise-proof ear-cover and suitable clothing
(drawing A).
IMPORTANT!
Check the air hose for perfect condition before connecting it with the quick air plug (10). It must be clear of bends and
cuts.
5

- OPERATING THE TOOL

5.1 Control devices

Start the tool by flattening the safety catch (12) forwards and by pressing the trigger (13).
Stop the tool by releasing the trigger (13).

5.2 Operating instructions

Always wear suitable protective clothing and accessories. Wear safety helmet, glasses, mask, boots or shoes and
gloves. Never wear a tie, scarf, necklace, belt or loose clothing which could get caught in the moving parts. Long loose
hair could get caught, too (Drawing A).

5.3 Trouble-shooting

PROBLEM
The hedge cutter does not work.
The hedge cutter has no power.
Air leaks from the handle valve (8)
of the extension pole (7).
The pneumatic motor jams.
The trimming blade (2) jams.
NOTE
If the above remedies do not solve the problem, contact an Authorised CAMPAGNOLA S.r.l. Service Point.
CAUSE
a) The compressor does not work.
b) The air hose is clogged.
a) The air hose is clogged.
b) The compressor does not pro-
duce enough air pressure.
c) Lack of lubrication in the pneu-
matic motor.
d) Condensation in the air tank.
The valve seals are worn.
The lubrication is insufficient.
Accumulation of cutting residues.
SOLUTION
a) Check the compressor for air production.
b) Remove the air hose and check it for clogs.
a) Disconnect the air hose and blow with compressed
air to remove the residues.
b) Check the air pressure in the compressor which
should be 800/1000 kPa (8-10 bar).
c) Check the oil level in the compressor lubricator.
d) Empty the compressor air tank.
Disassemble the valve (8) and replace all the inner
seals, even if slightly worn.
Pour few diesel drops or spray a little graphite into the
quick air plug (10). Let the tool idle for a while.
After having disconnected the air hose from the hedge
cutter, remove the residues.
19 - 52