Metric/ Imperial Setting; Error Codes; Transport And Storage; Additional Information - Tunturi T40 Manual Del Usuario

English
If you require spare parts, always give the model, serial number of
your equipment and the spare part number for the part you need.
The spare part list is at the back of this manual. Use only spare parts
mentioned in the spare part list.

Metric/ Imperial setting

When displayed speed is not matching your expectation the machine
might be set in incorrect setting.
Metric: Min./ Max. speed/:
1.0 Km/h/ 16.0 Km/h.
Imperial: Min./ Max. speed/:
0.6 Mls/h/ 10.0 Mls/h.
Switch units by:
Take off safety key. ( Console show E7)
Press and hold "Prog" & "Mode" button for 3 seconds.
Console shows shortly:
- 0.6 When switched to Imperial mode.
- 1.0 When switched to Metric mode.
Put Safety key back in position.

Error codes

If the display shows an error code
(marked with "E" + number), restart the equipment and check
whether the display still shows the error code. If the display still shows
the error code, immediately contact the dealer.
‼ NOTE
• E7 is not an error code, see "Safety key"

Transport and storage

⚠ WARNING
• Before cleaning and maintenance, remove the mains plug from
the wall socket.
• Carry and move the equipment with at least two persons.
• Make sure that there are no other persons or objects under the
equipment.
• When folding the folding the equipment, make sure that you
hear the equipment lock into position to prevent the equipment
from dropping back down.
⚠ CAUTION
• Before folding the equipment, make sure that the incline is 0%.
If the incline is not 0%, folding will damage the mechanism.
- Move the equipment as shown (fig. F3). Move the equipment
and carefully put the equipment down. Place the equipment on
a protective base to prevent damage to the floor surface. Move
the equipment carefully over uneven surfaces. Do not move the
equipment upstairs using the wheels, but carry the equipment by
the handlebars.
- Store the equipment in the upright position (fig. F1). Store the
equipment in a dry place with as little temperature variation as
possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites. We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres.
All manuals and user guides at all-guides.com
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from your
fitness trainer. However, a time will come when your fitness trainer will
come to the end of its useful life. Under 'European WEEE Legislation
you are responsible for the appropriate disposal of your fitness trainer
to a recognised public collection facility.
Parameter
Mains voltage
Mains frequency
Motor
Speed
Speed
Incline
Length (folded)
Length (folded)
Width
Width
Height (folded)
Height (folded)
Weight
Weight
Max. user weight
Max. user weight
HR. receiver
Tunturi New Fitness BV declares that the product is in conformity with
the following standards and directives: EN 957 (HC), 89/336/EEC. The
product therefore carries the CE label.
08-2019
Tunturi New Fitness BV
Purmerweg 1
1311 XE Almere
The Netherlands
© 2019 Tunturi New Fitness BV
All rights reserved.
The product and the manual are subject to change. Specifications can
be changed without further notice.
2 2

Technical data

Unit of measurement
VAC
HZ
HP
Km/H
Mph
Step
Cm
Inch
Cm
Inch
Cm
Inch
Kg
Lbs
Kb
Lbs
Khz

Declaration of the manufacturer

Disclaimer

Value
210~240
50~60
1.5
3.5 Max.
1.0~16.0
0.6~10.0
0~12
155.0
(87.0)
61.0 (34.3)
74.0
29.1
137.0 (139.0)
53.9 (54.7)
62.0
136.6
120
265
5.3 Khz