Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Remove the cross handle by pulling up on the handle. Tap with a rubber mallet, if required, to loosen and
remove the handle.
4.
Install the handle uprights (item 29) into the frame and install with the same hardware (items 48, 51 and 55) which had
been removed when the cross handle was removed. Be sure that the silver crush bushings are in place. Do not tighten
until the tubes are completely installed to the cross handle.
5.
Install the cross handle (items 28 and 34) onto the two support tubes. Install the two curved head screws (item 48)
from the accessory bolt bag and 13mm cap nuts (item 56).
English
9
HANDLE
UPRIGHTS
Customer Hotline 1-800-445-1805
Publicidad
Tabla de contenido
