Interchangeable Drilling Unit, 90°, 9 Spindles; Changing Interchangeable Drilling Units; Cleaning - BlueMax Mini Modular Plus Manual De Instrucciones

Setting up
Interchangeable drilling unit, 90°, 9 spindles
This interchangeable drilling unit is used for creating
holes at an angle of 90° (runners).
A maximum of 6 drill bits may be fitted with a maximum
diameter of 5 mm.
Drilling pattern
Bohrbild
L
L
R
32 32 32

Changing interchangeable drilling units

Depending on application, the appropriate
interchangeable drilling unit must be fitted for drilling
the required holes.
en
We will now show you how to change a drilling unit on
the basis of this example. When changing drilling units,
we recommend wearing safety gloves to prevent injuring
yourself on the sharp tools.
WARNING
Warning - Hand injuries!
Before resetting the machine, disconnect mains
plug and detach compressed air supply!
First undo star shaped grips
The safety catch
2
back to prevent it from falling. Lower interchangeable
3
drilling unit out of guide using grip
give safety catch
2
Set the interchangeable drilling unit aside.

Cleaning

Before fitting the required interchangeable drilling unit,
clean mating faces
cloth.
NOTE
Soiling results in rapid drive-component wear and
leads to malfunctions in the production process.
128
L
L L
R
R
R
32 32 32 32 32
256
until tool slips down.
1
holds the interchangeable drilling unit
. While doing so,
4
a short downward turn.
and drive sprocket with a clean
5 6
1
2
4
3
2
4
5
6