Centre Stop; Setting The Drum Stops; Pendulum Stops - BlueMax Mini Modular Plus Manual De Instrucciones

Centre stop

Centre stop

is used for installing connecting fittings or
1
as the first stop for the hole line.
Depending on working direction, flip up the right or left
hand stop lever. To adjust, undo knurled thumb screws
, and position centre stop by hand. Re-tighten knurled
2
thumb screws after completing adjustment.

Setting the drum stops

The drum stops provide set spacings.
Preset: 13 mm, 22 mm, 37 mm and 57 mm. Pull bench
back a short distance. For setting, turn the drum stop
to the required position and engage.
The unused position (position without stop pin)
represents the machine's zero point. This can be used
for resetting the digital display to zero.
Distance 13 mm interchangeable drilling unit,
9 spindles for drilling hole lines
Distance 22 mm interchangeable drilling unit,
6 spindles for hinge drilling
Distance 37 mm interchangeable drilling unit,
9 spindles for drilling hole lines
Distance 57 mm interchangeable drilling unit,
9 spindles for drilling hole lines
To set customised positions between 13 mm and 57
mm, use stop in the profile and set it to the customised
1
dimension (setting using digital display). Using screw
the position can be marked by moving the screw up to the
stop so as not to lose the position determined.

Pendulum stops

Adjust pendulum stops to suit application.
To make adjustments, undo screw
pendulum stop along rail. Re-tighten screw.
5
2
1
2
2
2
1
2
1
,
2
and move
4
4
5
en
133