Making The Machine Safe On Shutdown; Cleaning The Machine; Electric Motors; Servicing Work - BlueMax Mini Modular Plus Manual De Instrucciones

Recommendation
Only use genuine replacement parts.
Replacement parts or items of equipment not tested and /
or approved by Paul Hettich GmbH & Co. KG may impair the
machine's active and passive safety.
In all work, refrain from applying any abnormal level of force
above and beyond the extent necessary to undo / fasten
connections and/or screwed joints.
For maintenance work, only use suitable tools that are in
proper technical working order, using them correctly and in a
way that meets the safety requirements.

3. Making the machine safe on shutdown

• Switch OFF the power supply to the machine (unplug).
• Detach the compressed-air hose (compressed-air supply).
• Prevent the machine from being switched back on again
without authorisation.
• Clean the machine as described in the relevant section.
• Affix a warning sign to the machine in compliance with
accident prevention regulations.
DANGER!
CAUTION! Servicing work in progress!
Do not switch machine on
Ensure good pollution-control practice
Contaminated dirt (washing water, oils, greases) must be
collected and disposed of in accordance with regulations.

4. Cleaning the machine

The entire machine must always be cleaned after it has been
used. This is best done by wiping it down with cloths and / or
vacuuming it with an industrial vacuum cleaner.
NOTE
Never use compressed air to blow the machine clean.
Clean at shorter intervals if operating conditions make this
necessary.
Clean the machine
• only by suction as stipulated, never by blowing it clean
with compressed air,
• only with a dry cloth to remove left-on lubricants etc.,
• regularly clean off drilling dust.
Follow health and safety regulations and relevant provisions
when handling hazardous and/or groundwater polluting
liquids (e.g. oil, cleaning agents or solvents as well as other
chemical substances).
Never clean hands with aggressive, highly flammable and
health harming solvents or cleaning agents.

Electric motors

All electric motors must be cleaned at regular intervals
because dirt and dust act as an insulating layer which may
cause motors / coils to overheat.
Labelling, information signs
Labelling / information signs must be
• cleaned with a cloth,
• checked for secure attachment and legibility and
• replaced if they are damaged.
Laser
If using the laser, it must be cleaned at regular intervals
with a dry cloth.

5. Servicing work

Servicing and maintenance

Before attempting any maintenance measures, make sure that:
• the machine has been shut down and prevented from
switching back on again and cannot be started up
unintentionally or by mistake,
• the compressed-air supply to the machine is shut off and
the machine is depressurised.
Regularly check electrical cables and compressed air lines
on the machine. Immediately replace faulty or damaged
components.
WARNING
Risk of injury
Servicing and maintenance work must only be carried out
by instructed, qualified personnel.
Before attempting any servicing and maintenance work,
switch the machine off, disconnect the compressed air
supply and implement measures to prevent the machine
from being switched back on again without authorisation.
Only use genuine replacement parts. Replacement parts or
items of equipment not tested and / or approved by
Paul Hettich GmbH & Co. KG may impair the machine's
active and passive safety.
In all work, refrain from applying any abnormal level of force
above and beyond the extent necessary to undo / fasten
connections and/or screwed joints.
For maintenance work, only use suitable tools that are in
proper technical working order, using them correctly
and in a way that meets the safety requirements.
en
141