Hazardous Substances / Disposal; Protecting The Environment; Scrapping; Oil And Oily Wastes - BlueMax Mini Modular Plus Manual De Instrucciones

3. Dismantling
General information
Act with particular caution when dismantling the machine.
DANGER!
Warning! There is an elevated risk of injury
and accidents!
• Always wear ear protection when performing
very noisy work.
• Only use tested and approved tools for dismantling
the machine.
• Only use suitable and approved industrial trucks and lifting
gear (crane) for transporting the machine, assemblies and
components as well as for lifting heavy loads.
• Always use the prescribed personal protective equipment
(safety goggles, protective clothing, ear protection, safety
shoes etc.).
Dismantling the machine / system
NOTE
On dismantling also follow the information under
"Installing / fastening" in the section on "Technical
information".
• Undo all screw connections and label the screws and screw
positions in case the machine / system is ever re-installed.

4. Hazardous substances / disposal

Any disposal must be in accordance with regulations and in
observance of the law.
Dismantled components must be collected separately by
material group, non-recyclable residuals must be disposed of.
Observe the Regulation on Electronic Scrap when disposing
of drives and items of equipment as well as electric /
electronic components.
Maintenance (servicing) and repair work may produce
the following waste materials requiring disposal – at the
responsibility of the machine owner:
- lubricants, greases, oils and chemicals
- technical gases, e.g. nitrogen
- cleaning agents and expendables, as well as
- waste of all types, including worn machine components
and tools
- Liquid wastes must be collected as groundwater-polluting
substances in closed, approved containers and disposed of
in the proper manner
- Immediately bind and neutralise any spilled liquids
- Never allow spent auxiliary substances (e.g. waste oils) to
seep into the soil or sewer
Observe internal, local or regional provisions when disposing
of any item.
When disposing of the machine (dismantling or scrapping) all
components must preferably be recycled by material group.
After completely emptying and cleaning lubricant systems
(drilling units etc.), dismantling them may necessitate
disposal of the following material groups:
- metals: steel, grey cast iron, aluminium (mechanical engineering
materials),
- plastics: PVC (hoses),
- elastomers: cable coverings, seals,
- electrical devices / operating equipment
Sort machine parts before disposal and dispose of them in an
environmentally friendly manner.

Protecting the environment

CAUTION
The obligations prescribed in law with regard to avoiding
waste and proper recycling / disposal must be followed
during all work on and with the machines!
Particularly when carrying out installation, repair and
servicing work, substances hazardous to water, such as
• lubricating greases and oils
• solvent based cleaning fluids
must not be allowed to pollute the ground or enter the
sewer system!
These substances must be kept, transported, recharged
and disposed of in suitable containers.

Scrapping

If the machine is ever taken out of service for good, the laws
and regulations on disposal in force at that time must be
observed and met.
At the time of final shutdown and disposal, it is necessary to
dismantle and remove the entire energy supply system and
dispose of the lubricating oils.
At the end of their useful life, machines must be disposed of
by a specialist company qualified to do so.
It makes sense to check which materials can be recycled and
then also do so.

Oil and oily wastes

CAUTION
Caution!
Oil and oily wastes are a huge potential threat to the
environment. This is why they are disposed of by specialist
companies.
Channel these wastes into the company's internal
disposal department which will then pass them on to
specialist companies.
en
145