Ingersoll Rand AVC10 Manual De Operación Y Mantenimiento página 25

For Pistol Grip Handle Models
1. With a new Throttle Valve Face (30) installed on the
Throttle Valve (29), insert the Valve into the
Handle (27), slotted end down.
2. Place the Throttle Valve Spring (31) into the Handle
and secure with the Throttle Valve Cap (32).
3. Reinstall the Air Inlet Bushing (33).
4. Rotate the Handle in the vise to allow reinstallation of
the Throttle Lever (35).
5. Place the Throttle Valve Plunger (28) into the plunger
bore in the Handle.
6. Place the Throttle Lever into the Handle and secure
with the Throttle Lever Pin (34).
7. Put the Power Adjusting Valve (36) through the
Adjusting Valve Washer (38), raised detents of the
Washer toward the head of the Adjusting Valve, and
the Adjusting Valve Spring (39).
8. Screw the Adjusting Valve into the Handle.
9. Carefully drive the Adjusting Valve Stop Pin (37) into
the Power Adjusting Valve.
For the Button Throttle Model
1. Place the Push Button Throttle Valve (43) into the
Head Block (41).
2. Install the Button Throttle Valve Spring (47) and
secure it with the Button throttle Valve Cap (46).
3. Reinstall the Throttle Valve Button (42).
Assembly of the Riveting Hammer
1. Clamp the Handle of the Riveting Hammer in
leather–covered or copper–covered vise jaws with the
barrel bore upward.
2. Place the Valve Box Assembly into the Handle, larger
half of the Valve Box in first.
MAINTENANCE SECTION
3. With the Piston (6) in the bore of the Barrel (7, 8),
For Offset Handle Models
1. Place the Locking Key (3) into one of the slots in the
2. Secure the Locking Key with the Exhaust
1. Slide the Locking Ring (4) down the Barrel and
2. Secure the Locking Ring with the Exhaust
Nozzle Replacement for AVC26
1. Do not remove the Nozzle (9), which is used only on
2. Start the new Nozzle, plain end first, into the
25
screw the Barrel into the Handle.
Barrel/Handle Assembly.
Deflector (5).
For Pistol Grip Handle Models
interlocking the splines on the Barrel/Locking Ring
with the dogs on the Locking Ring/Handle.
Deflector (5).
Model AVC26, unless the Nozzle must be replaced.
Do not attempt to drive the old Nozzle out of the
Barrel; press it out.
One end of the nozzle bore is tapered and the other
is plain.
Barrel (8) with a soft hammer, then solidly support the
handle end of the Barrel and press in the Nozzle until
the plain end seats on the shoulder in the Barrel bore.