Programming A Bid Chip / Key; Menu Structure, Programming Procedure - ROBBE POWER PEAK TRIPLE EQ-BID 8541 Manual De Uso

POWER PEAK TRIPLE EQ-BID
8.

PROGRAMMING A BID CHIP / KEY

Insert
chip
Withdraw
chip
8.1

MENU STRUCTURE, PROGRAMMING PROCEDURE

'+' but-
ton
'ENTER'-
Taste
'+' but-
ton
'+'
button
'+' but-
ton
© robbe Modellsport
All manuals and user guides at all-guides.com
Operating instructions
If the charger is set to the Start display or any other
menu in the Set-up level, it will switch to BID chip
/ key programming mode as soon as a BID chip /
KEY is connected to the charger by means of the
adaptor lead. The same applies if the charger is
switched on with a chip connected.
In this initial menu you can set all the battery para-
meters which are to be stored in the chip. You can
also read out any stored charge or discharge values
(see Chapter 8.3). When you disconnect a BID chip
/ key, the charger leaves the programming menu
and reverts to the Start display.
ENTER'
button
ENTER'
button
ENTER'
button
16
'+'
button
'+'
button
'+'
button
Order No.
8541
ENTER'
button
ENTER'
button
ENTER'
button