Operation Tips; Maintenance; General Maintenance; Replace The Scraper - GreenWorks 2605302 Manual Del Operador

Turning the headlights off：
3. Release the bail switch (1).

10.7 OPERATION TIPS

• If it is possible, clear the snow with the direction of
the wind.
• In strong winds, lower the chute deflector to direct
the snow to the ground.
• When you complete the work, let the machine
operate for a while to prevent ice formation in the
discharge chute.
• If the snow is deeper than 8", decrease the speed
and let the machine work at its own rhythm.
• Do not use the scraper to remove compact snow
and ice.
11

MAINTENANCE

WARNING
Disconnect the extension cord before maintenance.
CAUTION
Use only approved replacement parts.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.

11.1 GENERAL MAINTENANCE

• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten all the fasteners and caps correctly.
• Clean the remaining snow on the machine with a
brush.

11.2 REPLACE THE SCRAPER

24
24
English
Use only approved replacement scrapers.
Wear heavy gloves or wind cloth around the impeller
when you touch the impeller.
1. Remove the screws (24) from each side plate.
2. Remove and discard the old scraper (8).
3. Install the new scraper (8).
4. Put in the mounting screw (25) and spacers and
tighten them.

11.3 REPLACE THE IMPELLER

Use only approved replacement scrapers.
1. Remove the 5 screws (24) and side wear pad (26)
that secure the right side cover (31).
2. Remove the nut (27).
25
11
WARNING
WARNING
WARNING
24
31
27
EN