Stage 2 Tray Assembly - Evenflo Exer Saucer Triple Fun Manual De Instrucciones

Stage 2 Base Assembly
M
7. Insert lower leg assembly
rock gently while applying a steady downward pressure until it snaps into place.
Swing lower leg assembly
four leg assemblies.
You are now finished assembling the base. Set it aside so you can assemble the tray.

Stage 2 Tray Assembly

D
C
B
F
C
C
M
at an angle (as shown) onto top of pedestal
M
up until it locks in the upright position. Repeat for all
F
A
M
C
C
1. Locate two tray halves
C
crown
E
Secure with four screws
Note: Hold the upper leg crown
securely while installing screws. Tension from the spring will
try to push the upper leg crown and pylon ring upward.
Repeat for other upper leg crown on this tray and for both
upper leg crowns on the other tray half.
1
D
A
3
2. Insert upper leg
snaps into place. Pull up on upper leg
securely installed in upper leg crown
Repeat until all four upper leg assemblies are
complete.
Note: Make sure the adjustment holes on the front of
F
all four upper legs
A
tray
4
M
C
, then
A
. Install spring
D
, and pylon ring onto one of the tray halves.
E
.
C
4
Install and tighten screws on the
pylon ring
sequence.
2
F
into the upper leg crown
F
are facing the outer edge of the
, as shown.
M
C
M
B
, upper leg
D
and pylon ring
TIP
D
in the following
C
until it
F
to ensure it is
C
.