Assembly And Use For The Single Serve Cup - Ninja BL820 Guia Del Usuario

Assembly and Use for the Single Serve Cup

ASSEMBLY
Fig. 9 Fig. 10
For best results, use short "PULSES"... Practice makes perfect!!
IMPORTANT: Make sure that the motor base is
plugged in for use.
1 Place the motor base on a clean, dry, level surface
such as a counter or table top.
2 Add ingredients to the single serve cup.
NOTE: Do not overfill! To avoid spilling, do not
add ingredients past the "Max" fill line.
3 Place the single serve blade onto the cup and
screw it on tightly until you have a good seal.
(Fig. 9)
4 Turn the single serve cup upside down and place it
onto the motor base, aligning the tabs on the cup
with the motor base. (Fig. 10) Turn clockwise until
the cup locks in place, the unit is ready for use.
(Fig. 11)
All manuals and user guides at all-guides.com
PULSE
Fig. 11 Fig. 12
5 The single serve cup only operates at one speed
regardless of which number is chosen on the dial.
Press down on the "Start/Stop/Pulse" toggle in
short intervals until you have reached your desired
consistency. (Fig. 11)
6 When you have reached your desired consistency,
turn the single serve cup counter-clockwise
(Fig. 12) and pull straight up to remove. (Fig. 13)
7 Turn the cup upright and remove the single serve
blade by twisting the blade assembly counter
clockwise.
8 Place the Sip & Seal To-Go drinking lid onto the
™
single serve drink cup, screw on to seal and enjoy!
9 Make sure that the motor base is unplugged when
not in use.
www.ninjakitchen.com
REMOVAL
Fig. 13
15