Bostitch BF33 Instrucciones De Funcionamiento Y Seguridad página 19

All manuals and user guides at all-guides.com
TROUBLESHOOTING GUIDE (continued)
SYMPTOM CAUSE
Drive blade Jammed nail and driver blade is
continues to get stuck in down position
stuck in down
Damaged driver/return
position
assembly
Material and fastener length
Debris in nosepiece
Tool operates Depth adjust set too shallow
but does not
Tool not firmly applied to
drive fasteners
workpiece
fully
Bump mode selected with long
nails (BF33 only)
Material and fastener length
Damaged or worn driver blade
tip
Tool used with non-mar tip
Damaged actuation mechanism
Tool operates, No nails in magazine
but no fastener
Wrong size or angle nails
is driven
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
Jammed nail Wrong size or angle nails
Magazine screws not secured
after previous jam clear/
inspection
Damaged or worn driver blade
Material and fastener length
Debris in nosepiece
Worn magazine
Damaged pusher spring
Dry fire lock out is engaged
with only 7-9 nails remaining
in magazine and the user is
applying excessive force to
contact trip, overriding the
lockout
FIX
Use stall release lever, clear and jammed nails, and
return driver blade manually if necessary.
Replace driver/return assembly. See authorised
Bostitch repair agent.
If the unit continues to stall (forcing the need to
rotate the Stall release lever) choose the appropriate
material and fastener length that is not too rigorous an
application.
Clean nose area and watch closely for small pieces of
broken nails stuck in the track.
Rotate depth adjust to a deeper setting.
Apply adequate force to tool securing it tightly to
workpiece. Refer to instruction manual.
Select sequential mode.
If the unit continues to stall (forcing the need to rotate
the Stall release lever) choose the appropriate material
and fastener length that is not too rigorous of an
application.
Replace driver/return assembly. See authorised
Bostitch repair agent.
Remove non-mar tip.
See authorised Bostitch repair agent.
Load nails in magazine.
Use only the recommended nails. Refer to Technical
Data.
Clean nose area and watch closely for small pieces of
broken nails stuck in the track
Clean magazine.
Replace magazine. See authorised Bostitch repair
agent.
Replace driver blade. See authorised Bostitch repair
agent.
Replace spring; See authorised Bostitch repair agent.
Use only the recommended nails. Refer to Technical
Data.
Make sure to tighten magazine hex bolts with wrench
provided.
Replace driver blade. See authorised Bostitch repair
agent.
If the unit continues to stall (forcing the need to
rotate the Stall release lever) choose the appropriate
material and fastener length that is not too rigorous an
application.
Clean nose area and watch closely for small pieces of
broken nails stuck in the track.
Replace magazine. See authorised Bostitch repair
agent.
Replace spring. See authorised Bostitch repair agent.
Load more nails in magazine to disengage dryfire
lockout.
GB
17