Electrical Safety; Assembly And Adjustments - Bostitch BF33 Instrucciones De Funcionamiento Y Seguridad

All manuals and user guides at all-guides.com
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger
b. Trigger safety lock-off
c. Contact trip
d. Depth adjustment wheel
e. Low battery and jam/stall indicator light
f. Stall release lever
g. Magazine
h. Pusher latch
i. Mode selector switch (BF33 only)
j. Rotating rafter/belt hook
k. On-board hex wrench
l. Battery pack
m. Non-mar tip
INTENDED USE
The BF33/BF33-2 cordless framing nailer has been
designed for driving nails into wooden workpieces.
The BF33 cordless framing nailer is designed for
sequential/bump modes. Nailers designed for
sequential/bump modes MUST NOT be used
on scaffoldings, stairs, ladders or ladder-like
constructions, e.g., roof laths. For exemptions
check your local national workplace regulations.
The BF33-2 cordless framing nailer is designed
for sequential only mode. Nailers designed
for sequential only mode MAY BE used on
scaffoldings, stairs, ladders or ladder-like
constructions, e.g., roof laths.
DO NOT use under wet conditions or in presence
of flammable liquids or gases.
These cordless nailers are professional power
tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for
use by persons (including children)
suffering from diminished physical,
sensory or mental abilities; lack of
experience, knowledge or skills
unless they are supervised by a
person responsible for their safety.
Children should never be left alone with this
product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your Bostitch charger is double insulated
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
Bostitch service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always remove the
battery pack. Always lock off the
tool before inserting or removing
the battery pack.
WARNING: Use only Bostitch battery
packs and chargers.
GB
11