Residual Risks - Bostitch BF33 Instrucciones De Funcionamiento Y Seguridad

All manuals and user guides at all-guides.com
Safety Instructions for Cordless
Nailers
• Always assume that the tool contains
fasteners. Careless handling of the nailer can
result in unexpected firing of fasteners and
personal injury.
• Do not point the tool towards yourself or
anyone nearby. Unexpected triggering will
discharge the fastener causing an injury.
• Do not actuate the tool unless the tool is
placed firmly against the workpiece. If the
tool is not in contact with the workpiece, the
fastener may be deflected away from your
target.
• Disconnect the tool from the power source
when the fastener jams in the tool. While
removing a jammed fastener, the nailer may
be accidentally activated if it is plugged in.
• Do not use this nailer for fastening
electrical cables. It is not designed for
electric cable installation and may damage the
insulation of electric cables thereby causing
electric shock or fire hazards.
• Always wear safety glasses.
• Always wear ear protection.
• Only use fasteners of the type specified in the
manual.
• Do not use any stands for mounting the tool
to a support.
• Do not disassemble or block any parts of the
fastener driving tool such as the contact trip.
• Prior to each operation check that the safety
and triggering mechanism is functioning
properly and that all nuts and bolts are tight.
• Do not use the BF33
– when changing from one driving location to
another involving the use of scaffoldings,
stairs, ladders or ladder-like constructions,
e.g., roof laths, etc.;
– when closing boxes or crates;
– when fitting transportation safety systems,
e.g., on vehicles, wagons, etc.
For exemptions check your local national
workplace regulations.
• Always check local workplace regulations.
• Do not use the tool as a hammer.
• Never actuate the fastener driving tool into
free space.
• In the work area, carry the tool at the
workplace using only one handle, and never
with the trigger actuated.
• Consider the conditions in
the work area. Fasteners can
penetrate thin work pieces or slip
off corners and edges of the work
piece, and thus put people at risk.
• Do not drive fasteners close to the
edge of the workpiece.
• Do not drive fasteners on top of other
fasteners.

Residual Risks

The following risks are inherent to the use of these
machines:
– Injuries caused by improper handling of the
tool.
– Loss of control due to not gripping tool firmly.
– Muscle strain of arms and hands, especially
when working overhead. Always take regular
breaks when working for long periods of time.
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
– Risk of personal injury due to prolonged use.
– Loss of control caused by recoil.
– Risk of injury caused by pinch points, sharp
edges and improper handling of workpiece.
– Risk of injury caused by sharp edges when
changing nails or inserting nail sticks.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Do not apply lubrication to tool.
Suitable nail collation angle.
Length of nails/
Nail thickness.
GB
7