Basic Table Saw Operation; Safety Power Switch; Work Helpers; Using The Miter Gauge With "T" Bar - Skil 3400 Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Basic Table Saw Operation

Safety Power Switch

NOTE: This table saw has a lockable feature that helps prevent
accidental starting.
1. To turn saw on, lift switch lever 1 by pinching side walls and
pulling up. This action starts the saw (Fig. 27)
2. To turn off power, push switch lever 1 down to it's original
position (Fig. 28).
3. Switch 1 can accommodate a padlock 2 with a long, 3/16" or
1/4" diameter shackle (not provided with table saw), to prevent
unauthorized use (Fig. 29).

Work Helpers

Before cutting any wood on your saw, study all of the "Basic Saw
Operations".
Notice that in order to make some of the cuts, it is necessary to use
certain devices, "Work Helpers", like the Push Stick, the Push
Block and the Auxiliary Fence, which you can make yourself.
After you have made a few practice cuts, make up these "helpers"
before starting any projects. Make the "Push Stick" first.

Using the Miter Gauge with "T" Bar

The miter gauge is equipped with a "T" shaped bar 12 which
engages under retaining tabs 13 in the table's miter gauge slots 14
(Fig. 30).
The tabs keep the miter gauge in the slot and will support it when
pulled beyond the front of table as shown in figure 31. When using
the miter gauge for 90° cross-cuts, the maximum cut capacity is
11-1/2 inches for up to 2 x 12 lumber (actual width= 11-1/4 inches).
The bar must be engaged under slot tabs before attempting any
cutting operation using the miter gauge.
FIG. 27
FIG. 28
FIG. 29
2
14
38.
("I") ON
("I") MARCHE
("I") ENCENDIDO
1
("O") OFF
("O") ARRÊT
1
("O") APAGADO
12
13
FIG. 30

Publicidad

Tabla de contenido
loading

Tabla de contenido