Operator Controls; Basic Operation; Temperature Control - Uline H-951 Manual De Instrucciones

Ocultar thumbs Ver también para H-951:

Manual del usuario (22 páginas)

Contenido

Tabla de contenido

Idiomas disponibles

Power Switch

1. Turn Power Switch ON. This starts machine and cooling fan.

2. Turn Heater Switch ON. This starts the blower, conveyor motors and heater.

3. Set Conveyor Speed. Set the Conveyor Knob between 1 and 3 until you determine the exact conveyor speed you

need, based on package size and sealer speed. Factory setting is 2.

4. Set Shrink Temperature. Use the Temperature Control to set the temperature that will shrink the material being

used. Adjust the temperature higher or lower as needed. Machine requires about 30 minutes to reach the set

temperature. Factory setting is 325ºF.

NOTE: The appropriate conveyor speed and heat setting for shrink wrapping your product will vary based

on type, thickness and brand of shrink film. We recommend shrink wrapping with the manufacturer settings

first and adjusting to suit your needs.

CAUTION! When turning the tunnel off, remember to turn off the Heater Switch FIRST. The tunnel

automatically shuts off at about 180ºF. Then you can turn the Power Switch OFF.

1. PV (Present Value) = Shows current operating

temperature of the machine.

2. SV (Set Value) = Shows the temperature you set for the

machine.

Moves indicator on SV display so you can set the

temperature.

and

adjust the number up or down

Automatic / Manual control.

A/M

Sets the temperature you have chosen as the Set

SET

Temperature.

TO ADJUST THE SET TEMPERATURE:

1. Press the

key. SV display flashes in 1st column.

While number is flashing, use the

your first desired number

2. Press the

key to move the indicator 1 place to

the left. While number is flashing, use the

keys to your second desired number.

PAGE 2 OF 21