SOMFY Sunea 50 CSI io Manual página 17

Adjustment for awnings without a cassette
For awnings without a cassette, the upper and lower end limits must be set.
Setting the upper end limit
Position the awning at the upper end limit.
1)
Pressing and holding the Up button for more than 2 s
causes the awning to move up continuously.
Stop the awning at the desired point.
2)
If necessary, adjust the position of the awning using the Up
3)
or Down buttons.
Press the My and Down buttons simultaneously: The
4)
awning will be lowered in one continuous movement, even
after the my and Down buttons have been released.
5)
the my button to stop the awning and move on to the next
step.
Setting the lower end limit
Position the awning at the lower end limit.
1)
Pressing and holding the Down button for more than
2 s causes the awning to move down continuously.
Stop the awning at the desired point.
2)
If necessary, adjust the position of the awning using the Up
3)
or Down buttons.
Press the my and Up simultaneously: The awning will be
4)
raised in one continuous movement, even after the my and
Up buttons have been released.
5)
the my button to stop the awning.
Press the my button again until the motorised product
6)
moves (1.5 s downwards then upward movement until the
awning closes): the end limits have been programmed.
Wait until the awning has stopped completely before going on
2.3.4. Programming the control point
The drive is in programming mode:
be programmed:
point is programmed in the drive.
If the drive is no longer in programming mode, repeat Step 2.3.1 before performing
Step 2.3.4.
Copyright © 2014- 2020 Somfy Activités SA, Société Anonyme. All rights reserved.
-
PROG button on the control point to
1 2
3 4
5
Move onto the next
1 2
3 4
5 6
PROG
Images not contractually binding
EN
step
17