Wiring - SOMFY Sunea 50 CSI io Manual

2.1.4. Fitting the emergency crank
-
with a 6 mm square pin (C) or a 7 mm hexagonal pin (D)
(accessories not supplied).
Fix the appropriate crank handle on the motor head.
-
2.1.5. Installing the drive/tube assembly
Fit the tube/motor assembly to the end bracket (f).
1)
Fit the tube/motor assembly to the motor bracket (g) with
2)
the cable outlet (h) pointing downwards.

2.2. WIRING

Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
The Sunea CSI io cable can be removed. If it becomes damaged, replace it with an
identical cable.
If the drive is used outdoors, and if the supply cable is a type HO5-VVF cable, the cable
should be installed in a UV-resistant duct, e.g. under a gland.
Leave the drive power supply cable accessible: it must be possible to replace it easily.
Always make a loop in the power supply cable to prevent water entering the drive!
Switch off the power supply.
-
Connect the drive according to the information in the table below:
-
Ensure compliance with standard NF C 15-100 relating to electrical installations
230V-50Hz
Copyright © 2014- 2020 Somfy Activités SA, Société Anonyme. All rights reserved.
-
Neutral Live
Blue Brown
Earth
Yellow/
Green
D
C
1
2
g
h
OFF
3 x 0.75 mm
1
230 V
2
~
3
50 Hz
3 x 1.5 mm 2
Images not contractually binding
EN
f
2
15