Descrizione Generale - RISCO Group RWX73F Manual De Instrucciones

Step 3: Selecting the Mounting Location
1. Select a location for best communication quality and near the intended wired detector. It's
recommended to place the unit at the highest possible position.
2. Temporarily attach the unit to this point using two-sided adhesive tape.
3. Generate an alarm signal (by momentarily opening or closing the input terminals) and verify
that the receiver has received the signal. If the alarm signal is not detected, reposition the
transmitter and try again.
Step 4: Mounting (Fig. 3 -- Fig. 6)
1. Detach back of transmitter from the back bracket (Fig. 3A). At mounting location note the
alignment marks for both components (Fig. 3B), and then install accordingly using 2 mounting
screws and back tamper screw (Fig 3C).
2. Detach magnet casing (Fig. 4A) and install with mounting screws (Fig 4B).
3. Optionally, mount spacer(s) for transmitter and/or magnet as required (Fig. 6), positioned
between the back bracket and the mounting surface.
NOTES:
• It's best to mount the transmitter on the non-moving part (door/window frame), and the
magnet on the moving part.
• Spacers are purchased separately (see table above).
• Align the marks on the magnet and transmitter cases (Fig. 5).
• For installations on wood or alloy, the maximum distance for normal operation is 10 mm (1
cm), while for metal ferromagnetic materials (such as iron) it is 5 mm (Fig. 5).
Step 5: Defining Parameters
These parameters can be defined for each channel from the control panel:
Parameter
Supervision
LED Enable
Magnet
Alarm Hold
Termination
Response
Anti-sabotage magnet
Shutter Pulse
* Channel 2 termination defined as Shutter

DESCRIZIONE GENERALE

RWX73F è un trasmettitore bidirezionale multifunzione a due canali che include un magnete per
controllare porte e finestre e due ingressi di allarme aggiuntivi (il primo per contatti porte/finestre
in serie al magnete e il secondo per contatti porte/finestre o contatti a filo per tapparelle). RWX73F
ha due reed utilizzati uno per controllare porte e finestre tramite un magnete fornito e l'altro per
proteggere l'unità da tentativi di sabotaggio realizzati utilizzando grossi magneti per inibire la
rilevazione di apertura del contatto.
Channel 1
Yes/No
Yes/No
Enable/Disable
On/Off
IN 1: NO/NC/DEOL
10ms / 500ms
Enable/Disable
--
5
Channel 2
Yes/No
Yes/No
--
On/Off
IN 2: NO/NC/DEOL/Shutter
10ms / 500ms
--
01—16*